04-25-2002 03:39 AM - edited 03-01-2019 09:29 PM
Hello,
this connection is only working if the port on the catalyst is configured as hd (HP switch is autosensing)
whereas the connection between the HP switch and a as fd configured FE interface on a router is working.
Any simliar expierences , any ideas?
Thanks and best regards
Marion
04-25-2002 08:44 AM
Many known issues with Cisco equip and auto-sensing. The best thing to do is to hard-code your duplex and speed settings an both sides of your connection to alleviate the possibility of these problems occuring. This is also known to create many CRC errors on ports.
04-26-2002 04:52 AM
Hi,
thanks for your attention.
We tried all possible hard-code variants already
without success.
We contacted HP as well. Maybe a firm ware upgrade is a solution.
Thanks again
Marion
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide