I need to configure a Fast Ethernet interface as a backup interface of a serial interface. I can enter the command but I need to know if this feature is supported by Cisco TAC. Where can I find information about this?
I am a bit worried about the backup interface being a FASTETHERNET interface. I know it works but I need to know if it if supported by Cisco TAC.
Some time ago, I open a case about a Fastethernet interface being backup of another FastEthernet interface. Cisco TAC engineer asked me that even if it works, it is not supported by Cisco TAC. I wanted to know if I will have the same problem.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...