Im having trouble conceptualizing how a fax server and a channelized T1 will work with an existing data network. A fax server sits on an ethernet segment, attached to a small/mid sized router (let us say a 26/36xx). The router has an existing WAN connection for data traffic. A new channelized T1 (analog trunks) will be brought in specifically for fax traffic. Do I put a NM-1CT1-CSU into the router? If so, how does this work? How does the router receive incoming fax traffic and know to send it to the fax server? How is it relating a called number to an IP address? What about outgoing faxes?
I think it must depend on the fax server. At my last organization we used Rightfax, and they make a T1 card that installs in the fax server. Faxes coming in are routed to the correct location by either the fax number, or an ID number placed at the end of the fax number.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...