I have one c3640 with FE and 4500 with Ethernet interface.I tried to connect back to back with crosscable and the configuration under c3640 FE interface with duplex half and speed auto.If I push the deplex to full, it will automatically drop the interface status to down.What actually happen when connecting to FE and Ethernet, perhaps on speed 10/100 to 10 Mbps or other related issue?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...