I'm configuring etherchannel betwee a 2948G-L3 and 2950 switches using four 10/100 connections. When i test the connectivity by pulling one or two cables, sometimes a connectivity is established sometimes not.
I really appreciate if you have some suggestions regarding this matter.
Does the link not comeup after you restore the connection or do you see some packet loss when you remove/insert link. If it's the later, I think it is because the port is added back to spanning tree, which causes a loss of connection on the channel until the link is forwarding again. An EtherChannel is preserved even if it contains only one port(due to a member going down) in CAT OS 6.3(x) and later but I believe we do not have this feature in IOS
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.