To enable the http server and to put an IP you must connect to the management port. The switch router has two management ports: a console serial port and an auxiliary port. The http server can be enabled by connecting to the console and entering the command 'Ip http server'.
The ping reachability problem might most likely be due to physical connectivity problem or due to the routing information not being learnt. Verify that:
1) The router has learnt the route to the destination
2) The status of the interface is UP and UP (sh ip int brie)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...