Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

filtering an Ethernet Mac address - DLSW.

I have a router running dlsw. There is a specific mac address off the Ethernet segment causing high utilization. How can I filter in this mac address from the ethernet segment/ DLSW SNA segment on the access router? The router is running transparent bridging.

#show bridge

Address Action Interface Age RX count TX count

0200.4020.000e forward Ethernet0 0 324495 0

Ethernet0 configuration shows:

interface Ethernet0

ip address x.x.x.x x.x.x.x

no ip directed-broadcast

bridge-group 1

bridge-group 1 spanning-disabled

What is the command to filter in the mac address above (in the show bridge).

Txs in advance.

Carlos.

1 REPLY
New Member

Re: filtering an Ethernet Mac address - DLSW.

Hello.

I think this should do te work :

access-list 700 deny 0200.4020.000e 0000.0000.0000

access-list 700 permit 0000.0000.0000 ffff.ffff.ffff

interface Eth 0

bridge-group 1 input-address-list 700

You can also look at http://www.cisco.com/univercd/cc/td/doc/product/software/ssr83/rpc_r/53998.htm

Boaz.

273
Views
0
Helpful
1
Replies