I have a router running dlsw. There is a specific mac address off the Ethernet segment causing high utilization. How can I filter in this mac address from the ethernet segment/ DLSW SNA segment on the access router? The router is running transparent bridging.
#show bridge
Address Action Interface Age RX count TX count
0200.4020.000e forward Ethernet0 0 324495 0
Ethernet0 configuration shows:
interface Ethernet0
ip address x.x.x.x x.x.x.x
no ip directed-broadcast
bridge-group 1
bridge-group 1 spanning-disabled
What is the command to filter in the mac address above (in the show bridge).
Txs in advance.
Carlos.