Now, I have two sites connected through two cisco routers running in bridge mode. (mainly because I have AS/400 on the network, so I bridge all traffic between two site.)
However, now I would like to lease different range of IP address & gateway on different site, such that users can use the nearest gateway to access to internet.
Site A by DHCP server A
IP range: 10.100.0.1-100 gateway 10.100.0.101
Site B by DHCP server B
IP range: 10.100.0.105-200 gateway 10.100.0.201
Currently, since I am in bridging config, users on site A will receive DHCP server on site B.
How can I filter the dhcp broadcast so that the dhcp traffic would not pass through the cisco bridge? I came across filtering using "Ethernet Type Codes", however, I can't find anything related to DHCP protocol.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...