I have a device that connect to a Catalyst 4006. the switch shows connected. However, when doing a show port command, there is no mac under " Last-Src-Addr". Despite this, I encode a IP in this device, and ping it from the switch. then it showed the Last-Src-Addr. But physically putting IP there is not practical in my case although it is successful.
My understanding would be that there is no traffic coming out/going into the device. therefore, I used many ways to sending traffic, including l2 tracert, ping broadcast, none of them succeeded.
My question for you is how can I let the switch show the Last-Src-Addr of that port?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.