Finding the IP address of the host connected in the Switch port
I have a Cat 4006 and I want to find out the IP address of the host connected with each port(other than trunk ports ). I need this info for documentation purpose which host is connected in waht port. I can find the MAC address (show cam dynamic ) and I don't know how to convert this MAC to corresponding IP address or it may be a single command in 4006 Switch to find the IP addresses (same like show arp in Router)
Re: Finding the IP address of the host connected in the Switch p
Once you know the MAC address, you can then go to the router that serves as the default gateway for that vlan, and check the arp entry for that MAC address on the router to see what the IP address of that host is.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...