you could use an IOS with the Firewall Feature set and IPSec 56 or higher. This would allow you to terminate VPN tunnels and at the same time protect your internal web server. Not sure if this answers your question...
Or you could use the PIX firewall which is more secure than the IOS based...If you are looking for a cheaper solution you can use the PIX 501 with one outside and one inside interface (4 port switch for the inside). You can configure the PIX for VPN client termination on the outside interface. The web server will be secured on the inside interface.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...