I bought used 16MB Flash memories for Cisco 2600. And installed it on Cisco 2500. The system could not recognize the Flash memory and serious error occurred when System Bootstrap run. It was as follows:
ERR: Invalid chip id 0x80B5 (reversed = 0x1AD ) detected in System flash
Can we upgrade Flash memories on EOS and EOL products?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...