Hi I upgrade the EOS in some FlexWan cards in 7609 equipments.
The EOS version I used is 0.28 (0x1c), 3 out of 4 worked fine, but with the last one the module got stucked, no answer. After investigating I realized that this module has a different hw version and most probably the min sw requirement was something higher than 0.28.
The question is how can force this module to boot from romon or is there any way to get the right sw version and put it into the card.
Your help is more than welcomed
Jorge
SLOT 9/0: 00:00:07: %EOS-2-EOS_INIT_FAILURE: The EOS FPGA initialization failed due to one of the QDR clocks not locked.
SLOT 9/0: 00:00:15: %EOS-2-NULL_EOS_OBJECT: The EOS device object pointer is set to NULL
SLOT 9/0: 00:00:15: %EOS-2-NULL_EOS_OBJECT: The EOS device object pointer is set to NULL
SLOT 9/0: 00:00:15: %EOS-2-NULL_EOS_OBJECT: The EOS device object pointer is set to NULL
SLOT 9/0: 00:00:15: %SLOT_FPD-3-GETVER_FAILED: Failed to get FPD version for FPD=2 in Slot 9: Cannot read version information.
SLOT 9/0: 00:00:16: %EOS-2-NULL_EOS_OBJECT: The EOS device object pointer is set to NULL
SLOT 9/0: 00:00:17: %SSA-5-FABRICSYNC_DONE: Fabric sync on Primary channel done.
SLOT 9/0: 00:00:17: %EOS-2-NULL_EOS_OBJECT: The EOS device object pointer is set to NULL
May 8 02:03:58: %DIAG-SP-6-RUN_COMPLETE: Module 9: Running Complete Diagnostics...
May 8 02:03:59: %SNMP-5-MODULETRAP: Module 9 [Down] Trap
May 8 02:03:59: %DIAG-SP-3-MAJOR: Module 9: Online Diagnostics detected a Major Error. Please use 'show diagnostic result <target>' to see test results.
May 8 02:03:59: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 9: BusConnectivityTest failed
May 8 02:03:59: %OIR-SP-3-LC_FAILURE: Module 9 has Major online diagnostic failure, Card will be powered down. Please check bootflash diaginfo file for detailed diagnostic result.
May 8 02:04:09: %C6KPWR-SP-4-DISABLED: power to module in slot 9 set off (Diagnostic Failure)
