Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FlexWan memory modules

Hi, all

I've a Router Cisco 7609 with 02 SUP2/MSFC2 running native IOS 12.1(19)E1 and one Flexwan (WS-X6182-2PA), and inside the Flexwan I've installed a PA-ATM OC3 SMI.

I'd like to know if is possible use a 64 memory board SODRAM in the left slot and 128MB memory on the right slot of the FLEXWAN module, I mean, use a 192MB on this module.

Or just use 64MB on the left and right memory slot OR 128MB plus 128MB in both memory slot's?

Antoher question is: Does the FLEXWAN work with just one memory board SODRAM in one memory slot? (e.g. just 128MB OR 64MB)

Tks

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: FlexWan memory modules

You have to use two 128M.

Flexwan memory information as the following:

# 64-MB Error-Correcting Code (ECC) synchronous dynamic RAM (SDRAM) memory for each port adapter slot, or 128-MB aggregate for the entire FlexWAN module (default)

#

* Configurable option for up to 128-MB ECC SDRAM memory for each port adapter slot, or 256-MB aggregate for the entire FlexWAN module

# 8-MB Flash memory

Regards,

Bessie

1 REPLY
New Member

Re: FlexWan memory modules

You have to use two 128M.

Flexwan memory information as the following:

# 64-MB Error-Correcting Code (ECC) synchronous dynamic RAM (SDRAM) memory for each port adapter slot, or 128-MB aggregate for the entire FlexWAN module (default)

#

* Configurable option for up to 128-MB ECC SDRAM memory for each port adapter slot, or 256-MB aggregate for the entire FlexWAN module

# 8-MB Flash memory

Regards,

Bessie

90
Views
0
Helpful
1
Replies
This widget could not be displayed.