Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

flow-control is XOFF in GEIP+

hi,

Does anyone see the information and tell me the meaning ?

best regards.

fred.

TPE7513-1#show int gigabitEthernet 4/0/0

GigabitEthernet4/0/0 is up, line protocol is up

Hardware is cyBus GigabitEthernet Interface, address is 0010.0da4.6880 (bia 0010.0da4.6880)

Internet address is 210.243.127.1/28

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 23/255, rxload 32/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 1000Mb/s, link type is autonegotiation, media type is SX

=========================================================

output flow-control is XOFF, input flow-control is XOFF

=========================================================

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 02:03:49

Input queue: 0/200/515/7038 (size/max/drops/flushes); Total output drops: 48556

Queueing strategy: fifo

Output queue: 0/200 (size/max)

30 second input rate 128026000 bits/sec, 28162 packets/sec

30 second output rate 90947000 bits/sec, 31609 packets/sec

197000194 packets input, 629065556 bytes, 0 no buffer

Received 17362 broadcasts, 0 runts, 0 giants, 4 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 5 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

221516729 packets output, 3267334097 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

4 lost carrier, 0 no carrier, 0 pause output

0 output buffer failures, 0 output buffers swapped out

1 REPLY
Silver

Re: flow-control is XOFF in GEIP+

If you mentioned about the info in between lines, that has got to do with flow-controll, shows to be off....

133
Views
0
Helpful
1
Replies