I am using NTP on my AS5200 and 3640's, but it isn't synching. Is there a way to force it to synch? Some of my routers are synching and some aren't. I have my routers set up w. the NTP server x.x.x.x pointing back to the main NTP server router. Do I need anything else?
You may need to set the system time on the router manually then apply NTP. NTP does not sync up properly if it is off by more than a certain amount of time. I do not remember the exact limit, but I know its more than 5 minutes. Also, have you checked that the NTP server has a route back to your router that is not syncing, and vice-versa?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...