I am trying to set up my router to forward incoming traffic to the appropriate device based on the incoming port. So that if I typed in 184.108.40.206:22 ? traffic would be routed to my SSH server in my DMZ at 192.168.15.10.
Everything else (internet) is working fine from behind the router. I believe I have the access-list setup correctly, along with the static nats. Here is my show run:
Current configuration : 1190 bytes
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
enable secret 5 $1$DY6rsFrs/dxSQTI6.PWPbdUNiI1
no network-clock-participate aim 0
no network-clock-participate aim 1
no aaa new-model
no ip domain lookup
no ftp-server write-enable!
ip address 192.168.0.1 255.255.255.0
ip address 192.168.15.1 255.255.255.240
ip nat inside
no ip address
ip address 220.127.116.11 255.255.255.252
ip nat outside
ip route 0.0.0.0 0.0.0.0 Serial0/0/0
ip http server
ip nat inside source list 1 interface Serial0/0/0 overload
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.