Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame relay configuration query

Can I add a point-point sub-interface with a frame-relay dlci command to a serial interface that already uses frame-relay map commands at the primary interface level; i.e. would both pimary and sub interfaces work on the same serial port?

Thanks and best regards

Keith

3 REPLIES
Bronze

Re: Frame relay configuration query

Keith,

This should work, but be sure to set a different network address on the sub-interface than you have on the physical interface.

Mark

New Member

Re: Frame relay configuration query

Hi Mark,

Thanks for that.

I'll go ahead and try that out.

Best regards

Keith

Bronze

Re: Frame relay configuration query

I dont think so. You need to move the maps and associated ip down to a sub interface of their own defined multipoint.

85
Views
0
Helpful
3
Replies
CreatePlease login to create content