well i am facing some troubles in configuring frame relay.
i have a cisco 2621 router connected to a frame relay cloud. and i do have 2 branch offices with 1750 routers. For each connection i have an independat DLCI number and network address. I configured serial sub interface point to point and did the map on each subinterface.
From the central site, i was able to reach both sites (pinging), same as remote sites with the central site. But i want the remote sites to talk to each other without going to the layer 3 on the router. I want them to be switched on layer 2 on frame relay. The central router is carrying voice same as the branch offices. Hope that the scenario is clear.
Sounds like you definitely need a connection directly between the 2 sites, either frame relay or leased line. Since you want to bridge between the 2 a leased line might be better because frame relay is best used for bursty traffic. Let me know if you need more info and we can discuss in greater detail.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.