I have the command Encapsulation Frame-relay ietf configured on my physical serial interface, and the command Frame-relay interface dlc1 56 ietf on my point to point subinterface. The PVC status comes up as deleted, when I changed the config on the phisical interface to Encapsulation Frame-relay the PVC status becomes inactive. Are there any known issues with both configurations, line protocol is down on the serial interface.
PVC status of inactive, could be a problem with the remote end. Check to see if LMI messages are being sent between your router and FR switch regularly. THe counts should be incrementing, each time you give the command " SHow frame-relay lmi"
If its not exchanging LMI, it could be either a problem with your CSU or a problem with the Provider. You might want to call your Service provider, and ask them to try looping your smartjack as well as CSU.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.