Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
275
Views
0
Helpful
1
Replies

Frame-relay encapsulation on E1-Link

w.susetio
Level 1
Level 1

‎07-29-2003 02:21 AM - edited ‎03-02-2019 09:11 AM

I'm trying to migrate the E1 link from HDLC to frame-relay encapsulation. It works using back-to-back UTP (1,2,4,5) cable. One end i configure as switching and DCE type. Clock rate set when configure as back2back. When run in real E1 link, the ping packet never reach 100 % success rate. (ping when HDLC configured is ok)

What is the possible reason?

Is there any parameter i can tuned?

The PVC is UP, DLCI Active and LMI is up.

Labels:
0 Helpful
1 Reply 1
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents