Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Frame Relay encapsulation

Dear Sir!

I've configure Frame Relay in my lab.

Q: Why if I've 'encapsualtion frame-realy IETF' on switch interface:

<lab configuration fragment>

interface Serial0/1

no ip address

encapsulation frame-relay IETF

no ip route-cache

frame-relay lmi-type q933a

frame-relay intf-type dce

frame-relay route 400 interface Serial0/2 110

frame-relay route 410 interface Serial0/0 200

& 'encapsualtion frame-relay' on my router interface:

<lab configuration fragment>

interface Serial3/0

bandwidth 512

ip address 192.168.1.53 255.255.255.224

encapsulation frame-relay

ipx network 100

no fair-queue

clockrate 2000000

frame-relay map ipx 100.0008.21c4.7460 400 broadcast

frame-relay map ip 192.168.1.33 400 broadcast

frame-relay map ipx 100.0015.44f4.9468 410 broadcast

frame-relay map ip 192.168.1.43 410 broadcast

frame-relay lmi-type q933a

my lab scheme still working? (s0/1 & s3/0 are directly connected)

Best regards,

Nick

1 REPLY

Re: Frame Relay encapsulation

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

122
Views
0
Helpful
1
Replies
CreatePlease to create content