07-03-2002 01:46 PM - edited 03-01-2019 11:31 PM
frame-relay end-to-end keepalive is a map class configuration. So does that mean that if I have this command on a router then the frame-relay end-to-end keepalive will run on all of its serial interfaces and sub-interfaces ?
07-03-2002 01:46 PM
The feature will only run on those
interface, sub-interfaces, or DLCI's
that have been specified. It cannot
be globally enabled.
The command "show frame-relay
end-to-end keepalive" should confirm
what is happening, too.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community