Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

frame-relay end-to-end keepalive

frame-relay end-to-end keepalive is a map class configuration. So does that mean that if I have this command on a router then the frame-relay end-to-end keepalive will run on all of its serial interfaces and sub-interfaces ?

1 REPLY
Anonymous
N/A

Re: frame-relay end-to-end keepalive

The feature will only run on those

interface, sub-interfaces, or DLCI's

that have been specified. It cannot

be globally enabled.

The command "show frame-relay

end-to-end keepalive" should confirm

what is happening, too.

78
Views
0
Helpful
1
Replies