11-22-2002 07:03 AM - edited 03-02-2019 03:06 AM
Hello.
I am trying to set up a test lab for frame relay. i have two 2620 routers plugged into one 2503 router with 2 serial ports. The 2503 is acting as the DCE for each. I am having two problems. I am unable to ping the router on the far interface of the 2503.(from the router on the s0 to the router on the s1). What do I need to do to enable this? Also I seem to be loosing packets somewhere, as my pings are only about 60% successful. Any advice would be great. Thanks in advance
Will
11-22-2002 07:26 AM
Make sure all the encapsulations are right.
11-22-2002 07:36 AM
all are frame relay
11-22-2002 08:01 AM
I have also tried to add a frame realy map and I get the following error
COl_2503_01(config-if)#frame-relay route 100 interface s1 200
can't route on this dlci as a map exists
COl_2503_01(config-if)#
11-23-2002 12:15 PM
The response that you got when you entered the frame-relay route command seems to indicate that you already have a map on the interface. Go through your configuration and remove any frame-relay map statements that you find.
Good Luck,
Mark
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide