Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame Relay question

Hello.

I am trying to set up a test lab for frame relay. i have two 2620 routers plugged into one 2503 router with 2 serial ports. The 2503 is acting as the DCE for each. I am having two problems. I am unable to ping the router on the far interface of the 2503.(from the router on the s0 to the router on the s1). What do I need to do to enable this? Also I seem to be loosing packets somewhere, as my pings are only about 60% successful. Any advice would be great. Thanks in advance

Will

4 REPLIES
New Member

Re: Frame Relay question

Make sure all the encapsulations are right.

Anonymous
N/A

Re: Frame Relay question

all are frame relay

Anonymous
N/A

Re: Frame Relay question

I have also tried to add a frame realy map and I get the following error

COl_2503_01(config-if)#frame-relay route 100 interface s1 200

can't route on this dlci as a map exists

COl_2503_01(config-if)#

Bronze

Re: Frame Relay question

The response that you got when you entered the frame-relay route command seems to indicate that you already have a map on the interface. Go through your configuration and remove any frame-relay map statements that you find.

Good Luck,

Mark

252
Views
0
Helpful
4
Replies
CreatePlease login to create content