We're looking at purchasing a frame relay connection between two locations (across town) and i'm wondering what router I should look at for it and what cards it would need. Probably just something low end, don't need anything huge.
Any router that can take a WIC-1T module or internal CSU should suffice. If you use a WIC-1T, you'll have to get an external CSU/DSU and a V.35 cable. It depends on your needs. If you have no need to split of channels on the T1 for voice circuits, use an internal Cisco CSU/DSU. The 160x are EOL. The replacement model is the 1700 series.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...