Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Frame Relay Simulation

I have a customer who is rolling out about a 115 new 2650XM routers.

These routers will have the built in CSU/DSU in slot 0 and ISDN Bri in slot 1.

They would like the frame relay operation tested. I was told about back to back frame simulation using the serial ports. How would you go about doing this with the csu/dus built in.

Any ideas on how to do this??

Thanks

1 REPLY
Cisco Employee

Re: Frame Relay Simulation

YES..you can configure one of the cisco router to act as "Frame-relay switch"

You can connect the routers using serial interfaces and create frame relay network. Pl. visit following link for that

http://www.cisco.com/warp/public/125/fr_switching.html

104
Views
0
Helpful
1
Replies
CreatePlease to create content