Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Frame -relay simulation

Can I do a simulation on frame-relay connection using 2 routers connecting each other by DTE and DCE cable such as PPP connection.

3 REPLIES

Re: Frame -relay simulation

You need a third router to act as a frame-relay switch.

http://www.cisco.com/warp/public/125/fr_switching.html

You need to use frame-relay encapsulations (such as cisco or ietf) between the routers.

Re: Frame -relay simulation

Or may be you were looking for this...

http://www.cisco.com/warp/public/125/frbacktoback.html

Bronze

Re: Frame -relay simulation

Last week I would have said it cant be done but I just found out this weekend that it can be done. It has limited use for point to point simulations.

config frame relay encap on both sides. Config frame intface-type dce and frame switching on one side. config both sides with the same dlci. Config clock rate on the sdie with the dce cable end (doesnt have to be the frame intf dce side).

109
Views
0
Helpful
3
Replies
CreatePlease to create content