Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame relay spoke to spoke routing

I have a frame relay setup with 5 spokes on point to point sub interfaces from my frame head end. I am trying to route traffic from one spoke to the other and seem not to be able to accomplish this using static or dynamic layer 3 routing. Is there something in layer two that I am missing that keeps me from accomlishing this? I am able to route traffic normally from host to spoke and visa versa. Any information would help. Thanks,

2 REPLIES
New Member

Re: Frame relay spoke to spoke routing

hi,

this MUST work !

do you have a defaultroute in your branchrouters ? - or only the network from the branch ?

New Member

Re: Frame relay spoke to spoke routing

I have a default route in all of my routers and it seems to be working on all other traffic. I am trying to go from one spoke to the other spoke via a trace and it dies at my head end router. That router holds a static route to send the traffic for this IP range to a sub interface. There is one configuration that I do have setup. All of my sub interfaces are unumbered ip.

93
Views
0
Helpful
2
Replies
CreatePlease to create content