Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Frame-relay switch simulator using 2500s

I need to simualte point-to-multipoint Frame-relay connection quite

urgently.

Unfortunately I have 4 cisco 2501 which as you know have 2 serial

inetrfaces each.

I understand that they could be configured back-to-back to effectively give

me a router with 4 serial interfaces. I would be most grateful if any of you knowledgeable guys can provide me the configuration for this scenario.

1 REPLY
New Member

Re: Frame-relay switch simulator using 2500s

The document/configuration you're looking for is archived on ccprep's website.

Try this link, and look around the middle of the document!

http://www.ccprep.com/resources/news/archives/990709.htm

204
Views
0
Helpful
1
Replies