Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Frame-Relay Switching and Tunnel

Hello,

I'm have 2 Cisco 2501, and I need configure them as Frame-Relay Switching, but this model has only 2 Serial interfaces, so I get some configuration examples that explain how configure Frame-Relay switching on a Tunnel using the Ethernet Interface, but some commands of this configuration are inexistent... here the command:

frame-relay route 113 interface Tunnel0 311

My IOS version is 12.0(6), on this version I can't use "frame-relay route XXX inteface TUNNEL XXX", the interface Tunnel is not accept, if I use help (?), the IOS displays only interface Serial option...

can you help me?

Regards,

Jefferson

CCNA / CCNP / CCAI

2 REPLIES
New Member

Re: Frame-Relay Switching and Tunnel

Hi,

You need Enterprise Edition IOS. To accomodate this IOS, You need 16 MB of RAM and 16 MB of flash, at least for IOS ver. 12.1

HTH

Giedrius

New Member

Re: Frame-Relay Switching and Tunnel

Thanks Giedrius...

your help is very useful!!!

110
Views
0
Helpful
2
Replies
CreatePlease to create content