09-03-2002 02:35 PM - edited 03-02-2019 01:06 AM
Hi Group,
I'm Setting up a lab for CCxx certifications per CCNA practical studies guide. Using 2501 with 2 serial interfaces. Frame-Switching is on. I can set intf-type on both serial ports, however I cannot get the clockrate to show on S1 when doing a show run. Also, I'm not seeing LMI on the remote router. Debug frame-relay lmi (on switch) shows S1(down) LMI timeout.
Any suggestions?
Thanks,
Todd
09-03-2002 07:12 PM
Are you sure you have a DCE cable in S1?
If not, it will not allow you to set a clock rate. This is independant of the intf-type being DCE, since this at the physical layer.
09-03-2002 07:29 PM
Thanks! Yes it was a cable, problem I had it reversed. ... I should have known to check the Physical layer first. It now works. Thanks again
Todd
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide