Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Frame Relay to ATM Network Interworking Bridging Configuration.

I am looking for a Bridging configuration between two sites.On central site ATM

with sub interfaces and on the end points Frame-relay . The bridge is needed to transfer LAT over the Interworking WAN .Can anybody help me with configuration?

Attached are configuration of the two ends. this is no working.

================Central Site =========================

interface FastEthernet0/0

description **** Connection to LAN ***

ip address xxxxxxx

bridge-group 1

!

interface ATM1/0

no ip address

no ip route-cache

no ip mroute-cache

no atm ilmi-keepalive

!

interface ATM1/0.32 point-to-point

bandwidth 128

ip address xxxxxxx

no ip route-cache

no ip mroute-cache

pvc 0/32

ubr 157

!

bridge-group 1

!

ibridge 1 protocol dec

!

==================end point=============================

interface Ethernet0

ip address xxxxxxx

bridge-group 1

!

interface Serial0

ip address xxxxxxx

encapsulation frame-relay IETF

keepalive 11

no fair-queue

frame-relay interface-dlci 16

frame-relay lmi-type ansi

frame-relay map bridge 16 broadcast

bridge-group 1

!

bridge 1 protocol dec

1 REPLY
Anonymous
N/A

Re: Frame Relay to ATM Network Interworking Bridging Configurati

Without the debug output, it will be difficult to find out where exactly the problem has occured.

But for making sure that the configurations are perfect, you can go through the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fibm_c/bcfpart1/bcftb.htm

112
Views
0
Helpful
1
Replies
CreatePlease to create content