Solved: frame relay traffic shaping

v-yelmene · ‎11-14-2003

If we have 'frame-relay traffic-shaping' enabled on the interface, but no map-class configured, will this default to 56K CIR?

thanks,

beng · ‎11-17-2003

Frame-relay traffic shaping is enabled on the main interface, and it applies to all DLCIs under that interface. We cannot enable traffic shaping only for a particular DLCI or subinterface under the main interface. If a certain DLCI has no map class attached to it, and traffic shaping is enabled on the main interface, the DLCI is assigned a default map-class with CIR = 56000.

View solution in original post

DAVIDE RENDINIELLO · ‎11-16-2003

Yes!

If you have a CCO login, look this link:

http://www.cisco.com/warp/customer/125/traffic_shaping_6151.html

beng · ‎11-17-2003

Frame-relay traffic shaping is enabled on the main interface, and it applies to all DLCIs under that interface. We cannot enable traffic shaping only for a particular DLCI or subinterface under the main interface. If a certain DLCI has no map class attached to it, and traffic shaping is enabled on the main interface, the DLCI is assigned a default map-class with CIR = 56000.