Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

frame relay traffic shaping

Hello. I have a frame-relay map-class set up on my DLCI for 128K but when I run the command show traffic-shape it shows that the target rate is 56000 what would be causing this?

Thanks

Will

2 REPLIES
Silver

Re: frame relay traffic shaping

Not enough information to answer this question, refer the following URL and verify your configuration

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080fdc.html#23472

New Member

Re: frame relay traffic shaping

Check your naming convention for the map class

The map and the class names must match

The map class name possibly doesn't exist that you are using under the sub-interface

note: the map -class name is case sensitive

87
Views
0
Helpful
2
Replies