Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

frame relay traffic shaping

If we have 'frame-relay traffic-shaping' enabled on the interface, but no map-class configured, will this default to 56K CIR?

thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: frame relay traffic shaping

Frame-relay traffic shaping is enabled on the main interface, and it applies to all DLCIs under that interface. We cannot enable traffic shaping only for a particular DLCI or subinterface under the main interface. If a certain DLCI has no map class attached to it, and traffic shaping is enabled on the main interface, the DLCI is assigned a default map-class with CIR = 56000.

2 REPLIES

Re: frame relay traffic shaping

Yes!

If you have a CCO login, look this link:

http://www.cisco.com/warp/customer/125/traffic_shaping_6151.html

New Member

Re: frame relay traffic shaping

Frame-relay traffic shaping is enabled on the main interface, and it applies to all DLCIs under that interface. We cannot enable traffic shaping only for a particular DLCI or subinterface under the main interface. If a certain DLCI has no map class attached to it, and traffic shaping is enabled on the main interface, the DLCI is assigned a default map-class with CIR = 56000.

109
Views
0
Helpful
2
Replies
CreatePlease to create content