Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Free Net with Caller ID accounting

I am try to configure Cisco 3600 Access Server ( E1 Channalized R2 signaling ) in a Free NET enviroment.

There is no user name and password for dial-up user.

Telcomm. is sending Caller ID to the Access Server.

I want the access server to get the CALLER ID ( caller phone number ) and send it to the TACACS+ Server ( Cisco Secure 2.6 ) for accounting perpose

My configuration :

controller E1 4/0

framing NO-CRC4

ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled

cas-custom 0

!

interface FastEthernet0/0

ip address 10.5.10.1 255.255.0.0

speed auto

full-duplex

!

interface Group-Async1

ip unnumbered FastEthernet0/0

encapsulation ppp

ip tcp header-compression passive

async mode interactive

peer default ip address pool test

group-range 161 190

!

ip local pool test 10.5.1.2 10.5.1.61

ip route 0.0.0.0 0.0.0.0 10.1.1.1

!

line 161 190

modem InOut

autocommand ppp

transport input all

autoselect during-login

autoselect ppp

!

Controller E1 is up , and working , NAS can ping the TACACS+ Server

TACACS+ address is 10.100.100.100

I need the access server commands that make the access server to get the Caller ID from the Telecom. and pass it to the TACACS+ Server for accounting

Thanks

Regards

Mohamed Abdallah

2 REPLIES
Cisco Employee

Re: Free Net with Caller ID accounting

Debugging E1-R2 signalling on 3600 platforms is not yet available in the ios.

So we can't debug the signalling part during witch the CLID or DNIS is received..Pl. make sure that the NAS is tunned to proper custom E1-R2 signalling based on the country. But we can just rely on aaa stack for that..So you can turn on following debug and see the CLID is even passed to ACS

debug aaa authentication

debug aaa authorization

debug aaa accounting

Bronze

Re: Free Net with Caller ID accounting

You will need to enable AAA, use accounting to get the info to the server, and don't use anything else. So try something like:

aaa new-model

aaa authen ppp default none

aaa author network default none

aaa account network default start-stop group tacacs+

!

tac server host 10.100.100.100 key foo

If there are any problems connecting once you enable this, try "debug aaa authen" and "debug aaa author"; otherwise, "debug aaa account" and "debug tacacs" to see the accounting info.

91
Views
0
Helpful
2
Replies