Can anyone tell us what the order is to remove traffic shaping on a hub and spoke topology. We tried removing the TS command on the physical interface on the hub with a result that all the spokes went down. When we tried to remove the map class from the DLCI on the spoke end that site went down.
I assume you are doing some fragmentation which is why removing the FRTS command causes loss of IP connectivity. The best possible way in this scenario is to be at the hub site and remove the map class from one remote site first, then immediately remove the map class from the hub site for that remote site ( or just remove the fragmentation commands from the map class)
This will still cause you to loose IP connectivity to the remote for a short period of time. Should be back up once you remove the map class from the hub, however connectivity will be slow till you completely remove FRTS from the hub ( asdefault class of 56K cir is taking effect)
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...