Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Full duplex with a 100 FX connection

Hello,

I have a WS-2960-24TC-L running with c2960-lanbase-mz.122-40.SE.bin with two GLC-GE-100FX= in it.

I am trying to link this switch to a 3750 with a GLC-GE-100FX= and a WS-2955C-12.

The 2960 always auto negotiate to 100 half with both switches. In the 3750 I can force the port to Full duplex but the DUPLEX command in not ava lable on gig 0/1-2.

I would be nice to have a 100 Full link between the switches.

Can you help me ?

2 REPLIES
Silver

Re: Full duplex with a 100 FX connection

What are your ports configured like on the 3750 and the 2955? Try setting each side for autonegotiate. This should bring the connection up at 100/full.

Steve

Green

Re: Full duplex with a 100 FX connection

Current GigE is full-duplex only.

You might try using a 10/100 port (as a trunk port if necessary).

You can also try another cable, preferably a commercially made cable in good condition. Poorly terminated hand-made cables, or cables that have been kinked, stretched, crushed {etc} can cause the ports to downshift.

Good Luck

Scott

204
Views
0
Helpful
2
Replies
CreatePlease to create content