Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

GBIC

With 5 Catalyst connect through Gigastack.

Can I connect them alternative one with port gi 0/1 the next with port gi 0/2 , the next with port gi 0/1 and so on ?

To my customer I had some problems perhaps about STP.

In fact if I entered sh spanning-tree I saw that the last switch of the cluster show like designated port gi 0/1(port 40) which wasn't connect.

I have connected all Catalyst on ports gi 0/1 and it seems work in order.

Is it possible?

Lorenzo

1 REPLY

Re: GBIC

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

119
Views
0
Helpful
1
Replies
CreatePlease to create content