Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Getting %LINK-3-UPDOWN ATM 5/1/0 changed state to up..BUT no down message

This message came from a 7507, but I'm not sure why I didn't see any Down messages.

Traps where also sent to HP OV. Any ideas???

2003-10-09 07:50:33 Local7.Error 10.84.0.6 72491: Oct 9 07:50:31: %LINK-3-UPDOWN: Interface ATM5/1/0, changed state to up

2003-10-09 07:51:02 Local7.Error 10.84.0.6 72492: Oct 9 07:51:01: %LINK-3-UPDOWN: Interface ATM5/1/0, changed state to up

7507A# sh int atm5/1/0

ATM5/1/0 is up, line protocol is up

Hardware is cyBus ENHANCED ATM PA

MTU 4470 bytes, sub MTU 4470, BW 40704 Kbit, DLY 190 usec,

reliability 255/255, txload 23/255, rxload 8/255

Encapsulation ATM, loopback not set

Keepalive not supported

Encapsulation(s): AAL5

4096 maximum active VCs, 475 current VCCs

VC idle disconnect time: 300 seconds

4 carrier transitions

Last input 00:00:00, output 00:00:00, output hang 20w3d

Last clearing of "show interface" counters 18w2d

Queueing strategy: fifo

Output queue 0/40, 1692479 drops; input queue 0/75, 14634 drops

5 minute input rate 1429000 bits/sec, 1283 packets/sec

5 minute output rate 3779000 bits/sec, 1256 packets/sec

1378690939 packets input, 2412118448 bytes, 0 no buffer

Received 0 broadcasts, 4172 runts, 0 giants, 649 throttles

132209 input errors, 132209 CRC, 1 frame, 0 overrun, 0 ignored, 0 abort

2336564128 packets output, 539256727 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

1 REPLY

Re: Getting %LINK-3-UPDOWN ATM 5/1/0 changed state to up..BUT no

Try configuring "logging event link-status" on the interface.

Cheers

109
Views
0
Helpful
1
Replies
CreatePlease to create content