Using CiscoWorks, I can pull a hardware report and get the serial numbers for about 37 switches out of 44 switches. However there are 7 that only give me blanks or 0x01 or 0x0D. Most of these 7 are the exact same model and IOS version as that of the other 37 which gives me the right serial number. So telnetting to them I do a show version and compare one that worked with one that did not and get different information, but they are the same IOS. Why is this and is there anyway to fix it?
Yes, I could do that, but it doesn't make sense that some of them pull it from the sh version without an entry for snmp-server chassis-id . Does anybody know why this serial number does not show up in some equipment when entering a sh version?
In case you haven't found a solution for this yet:
I had the same problem too. It was a while back so my memory is a little hazy but I think I deleted the snmp-server chassis-id line from the config, deleted the switch from ciscoworks, and then re-added it to ciscoworks.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.