Re: Getting the "Chassis" serial number off of remote 2600 route
To add to above, its a very good practice to store the serial number as part of the router configuration, either in the banners that you create, or in the snmp chassis-id command, so that you can remotely pull of the serial numbers without having to read it off the router physically. If you configure the serial using snmp, it will be easy to pull the info. through SNMP.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...