Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Gig E port in err-disable

I have a 6506 access switch with a gig port in err-disable. I shut/no shut the interface and it goes directly back into err-disable. I disconnected the cable from that port but still get the same problem. Any ideas before I open a TAC case?

4 REPLIES
Community Member

Re: Gig E port in err-disable

I had the same problem with an Uplink port. I had to add a command to the interface. I can't remember the command. I do know it was happening after a power generator test for the hospital.

Best thing is problably call the TAC.

Re: Gig E port in err-disable

Hello,

what is the cause of the errdisable state?

udld? link-flap ?

Please give us more information on this issue.

Vlad

Purple

Re: Gig E port in err-disable

Somewhere in your logs it should tell you why it errdisabled the port , need to look at that to get an idea.

Community Member

Re: Gig E port in err-disable

Here is the error message I get:

%PM-SP-4-ERR_DISABLE: diagnostics error detected on Gi2/41, putting Gi2/41 in err-disable state

Also I have inline power set to never, because we have no devices using inline power right now.

Thanks,

Bob

190
Views
0
Helpful
4
Replies
CreatePlease to create content