Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Gigabit etherchannel using 10/100/1000 ports

Is is possible to configure a gigabit etherchannel using the line ports of a WS-X4448-GB-RJ45 card configured in a Catalyst 4500, has anyone any experience of doing this. I understand that I will need to use cross-over cables but what other things do I need to take into account. What are the cons of doing this over using the ports in the supervisor engine..?

Thanks

Paul

1 REPLY
Cisco Employee

Re: Gigabit etherchannel using 10/100/1000 ports

You can certainly do etherchannel on 4448 blade.

The supervisor uplink ports are not oversubscribed, whereas the ports in 4448 are oversubscribed 8:1

80
Views
0
Helpful
1
Replies