11-27-2002 06:21 AM - edited 03-02-2019 03:12 AM
Is it possible to set the gigabit ethernet ports on Cisco 6500 to half duplex? And even if it is, is this going to cause problems? Its just that I've read on the TAC that these ports only support full duplex.
11-27-2002 06:38 AM
Nope it is not possible, the easiest way to tell is if you do a sh port cap x/x - naturally applies to CatOS.
Eg:
sh port cap 4/1
Model WS-X6408-GBIC
Port 4/1
Type 1000BaseSX
Speed 1000
Duplex full
Trunk encap type 802.1Q,ISL
Trunk mode on,off,desirable,auto,nonegotiate
Channel yes
Broadcast suppression percentage(0-100)
Flow control receive-(off,on,desired),send-(off,on,desired)
Security yes
Dot1x yes
Membership static,dynamic
Fast start yes
QOS scheduling rx-(1q4t),tx-(2q2t)
CoS rewrite yes
ToS rewrite DSCP
UDLD yes
Inline power no
AuxiliaryVlan no
SPAN source,destination
COPS port group 4/1-4
Link debounce timer yes
11-27-2002 08:59 AM
We upgrade the switches to IOS. Sorry I forgot to mention.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide