Hi just a quick question about graphing DSL.
Currently when I graph DSL I have to graph the virtual-interface which is bound to the dialer interface. Graphing the ATM interface and the virtual-interface give me the same results.
Graphing the dialer interface give me no results as this is showing as dormant.
The problem I have is that the graphing is showing peek rate of circa 256kb/s and will spike to 300kb/s.
Taken while downloading a large file:
dialer interface txload 124/255, rxload 115/255
5 minute input rate 959000 bits/sec
atm interface txload 6/255, rxload 204/255
5 minute input rate 242000 bits/sec
virtual interface 22/255, rxload 205/255
5 minute input rate 233000 bits/sec
I'm pretty sure the dialer interface is showing the correct d/l rate as it's a 2MB connection, but MRTG/PRTG can only seem to graph the ATM or Virtual interface, showing dialer as dormant?
any ideas
Cheers,
Ken