Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

GSR Linecard Question

Currently we have a 8 port ATM Over SONET OC-3c/STM-1 linecard. We want to be able to support Per packet load balancing but this card has engine 2 which will not.

Is there anything similar to this card that will support per packet load balancing?

  • Other Network Infrastructure Subjects
3 REPLIES
New Member

Re: GSR Linecard Question

Engine 2 line card does support per-packet load balancing.

However Globally you need to enable per-packet load balancing for the line card.(per-destination is by default)

(config)#hw-module slot number ip load-sharing per-packet

You will not be able use combination of both per-destination and per-packet load balancing in Engine 2 line cards at interface level.

As compared to Engine 0 / Engine 1 line cards(Interface level it is possible to use combination)

Pls refer to :

http://www.cisco.com/en/US/products/sw/iosswrel/ps1829/products_feature_guide09186a0080087c5b.html

New Member

Re: GSR Linecard Question

Thats really my issue, it will only be necessary on certain subinterfaces. Not globally. Any other recomendations?

New Member

Re: GSR Linecard Question

Presently E2 line cards does not support.

May be CISCO comes with a solution for such a requirements in future.

99
Views
0
Helpful
3
Replies